-52% 4 CH Active H/L 5V Relay Module

4 CH Active H/L 5V Relay Module

  • แบรนด์: China
  • รหัสสินค้า: BB-RELAY-5V-04

อุปกรณ์เสริมที่คุณอาจจะต้องการ

กรุณาใส่จำนวนที่ต้องการก่อนคลิกปุ่ม ‘เพิ่มในรถเข็น’

40 Ways Male to Female Jumper Wire

40 Ways Male to Female Jumper Wire

THB18.63 THB22.35 Ex Tax: THB18.63

  • อุปกรณ์เสริมทั้งหมด: THB0.0
  • ผลรวมทั้งสิ้น: THB58.86

  • สินค้าในสต๊อก:
    Backorder Only
  • ระยะเวลาในการรับประกัน: 12 เดือน
  • Shipping:

Relays are always good to have especially for electronics projects. Relay itself offers two main benefits:

  • Isolation of low voltage system against high voltage system, example 5VDC and 240VAC
  • Allow electronics with low voltage to control high power load, example from Arduino to AC light bulb.

This is not an ordinary Relay breakout. It comes with 4 channels of 5V activation relay, ready to control 250VAC at 10A. Extra isolation with opto-coupler at the front end of control, and the activation logic for each channel is configureable via mini jumper. In simple words, each relay can be configured as 5V(High) activation or 0V(Low) activation. And Yes, each relay, individually. This is the universal Relay breakout board that I like it.

This is ready breakout board with four (4) 5V activated relays, with 3 screw terminals for each relay (NO, NC, COM) and screw terminals for control signal from microcontroller such as Arduino. Each control signal is opto-isolated, protected. It even comes with activation LED indicator for each relay. Easy to use and suitable for beginner, and of course student too.

If you need to control AC or high current, high voltage load, this will be the perfect board.

Features:

  • 5V 4 channels relay module
  • Configureable Activation Logic, High or Low, via mini jumper
  • Maximum Current Rating: 10A
  • Maximum Voltage Rating: AC 250V
  • Can control various appliances with large current and high voltage
  • Can be controlled directly by microcontroller such as Arduino, 8051, AVR, PIC, DSP and ARM
  • Build in 4 units of Opto-Isolator for extra isolation and protection to controller.
  • A power indicator LED, Green
  • Each relay comes with an indicator LED

Resources:

Hi, can one screw the jumper wires from the Arduino into the inputs marked IN1-IN4? ( Hua Jie , 25/06/2020 )
Hi, yes can. Thanks :)
Hi there, wondering whether the module is capable of supporting higher than 5V, maybe 12V or higher? What is the maximum supported voltage? Thx ( C.H.LEE , 15/02/2020 )
Hi, yes. But, resistor is needed to be added at the input as it uses optocoupler, rating 5mA. Thanks :) 

Ask a question

Note: HTML is not translated!
  • 4.9 out of 5
                  
ความคิดเห็นทั้งหมด (20)
  • 5
    95%
  • 4
    0%
  • 3
    5%
  • 2
    0%
  • 1
    0%

แท็ก: 4 channels, Opto isolated, Active High, Active Low, trigger, optocoupler, H/L Level