Universal e-Paper Raw Panel Driver HAT

THB385.46 (VAT included)
เงินคืน: THB10.81
  • 5 ชิ้นขึ้นไป THB346.57
  • 20 ชิ้นขึ้นไป THB307.69
  • 50 ชิ้นขึ้นไป THB289.09
  • สินค้าในสต๊อก: 3
    • ส่งจาก: Malaysia

    Buy locally from a partner

    ประเทศ:
    รายละเอียด

    This is a universal driver board for e-Paper raw panels, can be used to drive various SPI interface e-Paper from that we carry.

    Out of the box, it can be stacked on the Raspberry Pi board through the 40-pin GPIO, getting the power and communication from the Raspberry Pi board. So it is compatible will all the Raspberry Pi board that has 40-pin GPIO, except the CM (Compute Module).

    Note: e-Paper display and Raspberry Pi are NOT INCLUDED in the package.

    ระยะเวลาในการรับประกัน: 12 เดือน
    คุณสมบัติ
    • Standard Raspberry Pi 40-pin GPIO extension header, supports Raspberry Pi series boards, and also Jetson Nano
    • SPI interface, for connecting with other controller boards like Raspberry/Arduino/Nucleo, etc.
    • Onboard voltage translator, compatible with 3.3V/5V MCUs
    • Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
    • Operating voltage: 3.3V~5V
    • Interface: 3-wire SPI, 4-wire SPI
      • VCC - 3.3V~5V
      • GND - Ground
      • DIN - SPI MOSI pin
      • CLK - SPI SCK pin
      • CSSPI chip selection, active low
      • DC - Data/Command selection (high for data, low for command)
      • RST - External reset, active low
      • BUSY - Busy status output

    • Outline dimension: 65mm × 30.2mm
    • Mounting hole size: 3.0mm

    รายการบรรจุภัณฑ์

    Packing list:

    • 1 x e-Paper Driver HAT for Raspberry Pi
    • 1 x RPi screws pack
    • 1 x PH2.0 20cm 8 Pin

    แหล่งที่มาข้อมูล
    Q & A

    Ask a question

    ความคิดเห็น
    • 5 out of 5
                    
    เรียงตาม:

    แท็ก: E-paper, Eink, E-ink, epaper, driver