Digispark Attiny85 USB microB Arduino Compatible

The Digispark is an Attiny85 based microcontroller development board similar to the Arduino line, only cheaper, smaller, and a bit less powerful. With a whole host of shields to extend its functionality and the ability to use the familiar Arduino IDE, the Digispark is a great way to jump into electronics, or perfect for when an Arduino is too big or too much. This version of the board comes with a USB micro B receptor so you do not need to connect it to your laptop's USB port directly. You can power it, load the program while using it.

Note: The Digispark is shipped fully assembled except for the two included and easy to solder headers.

• Support for the Arduino IDE 1.0+ (OSX/Win/Linux)
• Power via USB or External Source - 5V or 7-35VDC (12V or less recommended, automatic selection)
• On-board 500ma 5V Regulator
• Built-in USB
• It comes with a USB micro B receptor, extendable with Android phone USB cable or USB micro B cable.
• 6 I/O Pins (2 are used for USB only if your program actively communicates over USB, otherwise you can use all 6 even if you are programming via USB)
• 8KB Flash Memory (about 6KB after bootloader)
• I2C and SPI (vis USI)
• PWM on 3 pins (more possible with Software PWM)
• ADC on 4 pins
• Power LED and Test/Status LED

• 1 x Digispark board with USB micro B receptor
• 1 x 9-way straight header pin

• Wiki Page
• Schematic
• Software
• Digispark with Arduino IDE, tutorial by electronicGure in Instructables
• 40 DIY Digispark projects by Hackster.io