True color RGB LED HAT (8x8) for Raspberry Pi, colorful display

This RGB LED HAT gives your Raspberry Pi (Zero or 3B) the capability to display colorful effect, and controlled by only one signal pin. This HAT consist of 64 of RBG LED (WS2812B). These RGB LEDs are controllable Schedvia only 1 pin and addressable (each and every LED can be controlled). 

Just stack this pHAT onto your Raspberry Pi Zero or 3B+, the hardware setup is done. It is that simple!

Features:

• Supports any revision of Raspberry Pi (directly-pluggable)
• Onboard 8 × 8 RGB LED (WS2812B)
• Control pin is configurable via jumpers (0Ω resistor), by default is connected to P18 of Raspberry Pi GPIO.
• Break out control pins, easy for working with other MCUs
• Comes with development resources and manual (examples in Python and Web control)

Specifications:

• Operating voltage: 5VDC
• Brightness: adjustable 256 levels
• Color depth: 24-bit true color (8-bit for R/G/B respectively, totally 256x256x256=16777216 colors)
• Data rate: 800Kbps(typ)
• Dimension: 65mm × 56.2mm
• Mounting hole size: 3.0mm

Although it is designed as Raspberry Pi HAT, but you can still use it with any MCU:

• 5V ↔ 5V power
• GND ↔ GND
• DIN ↔ Signal input

Dimension:

Packing List:

• 1 x RGB LED 8x8 HAT board
• 2 x 10mm spacer (2.00 mm diameter) with screws and nuts

Documents/Tutorials/Codes:

• Wiki Page - How to use it
• Schematic
• WS2812B Datasheet
• Demo code
• Rpi_ws281x-master