10-Channel 32-bit ADC HAT for Raspberry Pi

Sensors with analog signal are very common in digital making, but there is no analog input pin at all Raspberry Pi computers. Thus, this analog to digital converter (ADC) is designed for you to use analog sensors with your Raspberry Pi. It can be used with Raspberry Pi 2/3/4/Zero and Jetson Nano B01 4GB dev kit. 

You can connect sensors at the green terminal block or the yellow pin headers. 

Specification:

• Adopts ADS1263 chip, low noise, low-temperature drift, 10-ch 32-bit high precision ADC (5-ch differential input), 38.4kSPS Max sampling rate
• With embedded 24-bit auxiliary ADC, internal ADC test signal, IDAC, 2.5V internal reference voltage, 8x multiplexing GPIO, PGA (32 times Max)
• Onboard AD header input, compatible with Waveshare sensor pinout, for connecting sorts of sensor modules
• Onboard AD screw terminal input, allows connecting analog signal and analog power supply, general purpose interface
• Onboard control header, make it easy to control the module by other hosts in addition to Raspberry Pi
• Three-wire RTD (resistor temperature detector) circuit, enabled by soldering 0R resistor

• 1 x 10-Channel 32-bit ADC HAT for Raspberry Pi
• 1 x RPi HATscrews pack

• Product wiki page, by Waveshare