Octopus Digital Push Button Brick - Blue Button

Octopus Electronic Bricks, you can use them to build electronics projects just as easy as piling bricks. By using Octopus electronic bricks, you may connect Arduino/Freaduino compatible boards easily with various digital, analog, and I2C/Uart interfaces. These the breadboard-less firm connection are prepared to extensive modules like potentiometers, sensors, relays, servos even buttons, just plug and play.

This is a digital push-button sensor, which detects your press action. It is ideal for beginner class to test the Arduino or be your first sensor in your project. It was easy to be used for Chipkit, STM32, AVR, ARM, and other micro-MCU.

As the connector is SVG, this module/brick is compatible with:

• ElecFreaks sensor:bit for micro:bit (sensorbit)
• ElecFreaks Motor:bit for micro:bit
• microbit GPIO Expansion Board
• Kittenbot ROBOTBIT V2.1

Dimension:

Quick Start:

Hardware Connection：

Connect to the P1 port on sensor:bit.

Programming：

Click the "Advanced" selection in the Makecode to check more coding selections.

We need to add a package for the coding. Click "Add package" from the bottom of the page and search"Tinker-kit" in the dialog box, then download the equivalent package. (Pointed by the red arrows below)

Code:

Program links: https://makecode.microbit.org/38481-95858-44715-13060

Results:

While the button is pressed, an icon is showing on the micro:bit; while released, a rectangle is showing on the micro:bit.

• 3P buckled wires connector
• Plug and play
• Large button keypad and high-quality first-class hat
• Able to achieve very interesting and interactive work
• Power supply needed: 3.3V-5V
• Interface type: Analog
• Pin Definition:
  • S- Signal
  • V- VCC
  • G- GND
• Size: 38.9x23.5mm

Packing list:

• 1 x Octopus Digital Push Button Brick - Blue Button
• 1 x Analog Sensor Cable

• Wiki page for more info about this product.
• Octopus Digital Push Button Brick source code